Reversomatic Deluxe Series Bedienungsanleitung

HRV / ERV INSTALLATION AND OPERATING INSTRUCTIONSDeluxe Seriesmodel:RHRV-D100AAluminum CoreRHRV-D100PPolypropylene CoreRERV-D100Enthalpy CoreC

HRV and ERV Typical Installations (Deluxe Series)82 Single VentsSVE-50 and SVI-50 Shown.“Fresh Air/ Exhaust Air Vents Installation”HRV/ERV (SUPERIOR)R

HRV and ERV Typical Installations (cont’d)9HORIZONTAL • 32” clearance is recommended for cleaning of the core/servicing the unit. (use appropriate a

Drain Connection During defrost cycle the HRV unit may produce some condensation and the water should flow into a nearby drain.The HRV cabinet has pre

Air Flow Balancing 11Pitot Tube Airflow Balancing The following is a method of field balancing an HRV/ERV using a Pitot tube advantageous in situation

Air Flow Balancing (cont’d)DUCT DIAM.5"6"CROSS SECTION AREA0.136 sq. ft.0.196 sq. ft.The accuracy of the flow reading will be affected by ho

Repeat steps 1 to 5 from the previous section and continue with the following steps: 1. Clean the HRV and ERV core: - Remove filters

Troubleshooting (cont’d)14PROBLEMS SOLUTIONPOSSIBLE CAUSES5. Timer switch 20/40/60 minute light doesn't stay on- loose connection- the switch

IMPORTANT READ AND SAVE THESE INSTRUCTIONS SAFETY INSTRUCTIONSwww.reversomatic.com • [email protected] WARNING! !TO REDUCE THE RISK OF FIRE, E

Parts List11326561315217161479111012181974821202223*24*25*26*Optional Parts:*14a43c

Wiring Diagram2Note: 3 Wall-controls and 2 Timer switches or 2 wall controls and 3 Timer switches or 1 wall control and 4 Timer switches can be connec

Never connect a 120 volt AC circuit to the terminals of the furnace interlock (Standard Wiring). Only use the low voltage class 2 circuit./fan-coil/he

HRV/ERV Operational Modes Functionality4Off Mode: HRV/ERV fans are off. Defrost damper is closed to prevent cold air from entering the unit.Normal Mod

Programming Instructions for Wall Control Unit (WC100)5Normally there will be only one Wall Control Unit connected to Control Board. Multi Wal

NOTE: There are totally 9 Defrost Maps. Map1-3 are forAluminum Core (RHRV-D100A). Map 4-6 are for Polypropylene Core (RHRV-D100P). Map 7-9 are for ER

Programming Instructions for Wall Control Unit (cont’d)7After pressing the MODE button,the unit switches to Airflow Balancing disable/enable setting.T